• Additional M/S-technology: This equalizer can also work in M/S mode. That can almost work as a remixer!

• Type II: Works more like Gerzon shelf-like equalizing. Use less, get more!

• Analog Mode: This gives the signal analog-modeled distortion/coloration which can add excitement to any signal. You can also drive the circuits more with this feature enabled.

• Presets: pre-selected frequencies.

• Clip LED for overloads.

• Dynamic DSP: functions which are not used are not loaded onto DSP’s for highly efficient DSP usage.

• Phase Alignment Technology: the processed and unprocessed signal stay in phase. In other words the bypassed plug-in has the same sample-accurate latency as non-bypassed.

• MIDI-controllable: Control the parameters with an external MIDI-controller. Easy to set up!

• Large GUI with “analog-style” look and feel.

• Compatible with Scope software 5.x

• Compatible with all Scope hardware

• 96kHz capable

• Gain/Level: -∞ to +12dB

• Gain on all bands: -12 to +12dB 

• LF Freq: 30, 60, 90, 120, 175, 250 Hz 

• LMF Freq: 250, 500, 800, 1k, 1.6k, 2.2k Hz 

• HMF Freq: 1.5k, 2.2k, 3.6k, 5k, 7k, 10k Hz 

• HF Freq: 2.2k, 3.6k, 5k, 8k, 12k, 15k Hz

• M/S: Switch to MS Mode; M on left, S on right 

• Type II: Enable Gerzon-like filters, use less to get more. 

• Analog: Enable analog modeling distortion and coloration

The dNa Stereo Equaliser will use roughly between 470 ~ 960 DSP Cycles depending on settings on the old 60MHz SHARC (older Creamware cards). (Max less than one Sharc)